Strumco Air Starter
7127-68 Avenue NW
Edmonton, Alberta
Canada T6B 3T6
Office:
780.468.0050

Email Us

Visit Us On FacebookVisit Us On TwitterVisit Us On Google PlusVisit Us On Youtube

POW-R-QUIK PRQ–LS8 Air Starter      

 For engines up to 400 CID (6.5 liters) Diesel 

LS-8 Model Vane Air Starter available at Strumco Air Starter

For engines up to 400 CID (6.5 liters) Diesel 800 CID (13.10) gas

 

  • LS-8 air starters combine power and reliability in a simpler, compact design.
  • Fewer parts in motor section.
  • Drive section uses smallest air starter inertia drive available which is pinned directly to the arbor shaft.
  • For small engine mounting, this starter air available at Strumco Air Starter can be indexed at 40° increments at the motor and additional 60° increments at the drive.
  • The use of shims allows mounting flange to ring gear dimensions to be adjusted to fit non SAE dimensions without costly flange adaptors.
  • Machined flanges allow new flanges to be available in days, not months.
  • Pinions for all SAE standard and most Metric ring gears

The LS-8 air starter available at Strumco Air Starter is able to fit into very small packages with its gear reduction off set design. With over 80 models LS-8 air starters available at Strumco Air Starter will fit almost any engine in the under 400 CID range. Lubeless blades and its hard coated aluminum cylinder and teflon coated end plates makes it a very corrosion resistant starter.

LS-8’s air starter design allows it to be modified to accommodate almost any flange type and by shimming its universal drive housing any flange to ring gear spacing can be achieved. Special pinion gears can be cut if required from LS-8’sair starter  investment cash pinion and barrel blanks.

Send Strumco Air Starter a drawing of your electric starter and there is a good chance a LS-8 air starter model can be created to fit your special needs.

 

 

 

 

 

 

                   ls8-schem2

POW-R-QUIK LS-8

The use of shims allows mounting flange to ring gear dimensions to be adjusted to fit non SAE dimensions without costly flange adaptors.

ls8-parts

Machined flanges allow new flanges to be available in days, not months.

ls8-parts

Pinions for all SAE standard and most Metric ring gears.

Strumco Air Starter
Ph:  780.468.0050
sales@strumco.com